Stitch - Kenmore 385.19110 Owner's Manual

Zipper Sewing (continued)
[21
Sew through all layers the entire length of the
zipper tape, removing the pins as you go. Stop the
machine about 2" (5cm) before the zipper foot
reaches the pull tab. Lower the needle slightly into
the fabric. Raise the zipper foot and unzip a few
inches to clear a path for the stitches. Lower the
foot and stitch the remainder of the seam.
_i_ Pull tab
_2_ 2" (5cm)
[31Remove the fabric and close the zipper. Take the
upper fabric layer and lay it flat on the zipper.
the upper fabric layer to the zipper tape.
_3_ Wrong side of upper fabric
_4_Basting stitch
_5_Right side of fabric
_6_ Zipper tape
[13Raise and
side of the
to the right
and stitch
guiding the edge
ol :-hand
bottom stop, up
h. Turn fabric 90 °
zipper tape,
along the zipper teeth.
[5_Before reaching pull-tab, stop the machine
with needle in fabric and raise the foot. Use seam
ripper to open a few inches of basting stitches,
then unzip a few inches to clear a path for the
stitch.
_7_ Basting stitches
[61Lower the foot and stitch the remainder of the
seam, making sure the fold is even. At the end of
the seam, sew in reverse a few stitches to lock.
Once both sides of zipper are sewn, use seam
ripper to open the basting stitch.
f
%
%
%
%