Replacing Control Panel Label - Invacare Solo2 TPO100B Internal Repair Manual

17 CONTROL PANEL

17.2 Replacing Control Panel Label

1. Peel the control panel label off of the top of the SOLO
 Invacare recommends using isopropyl alcohol to remove residual glue from the top of the unit. The use of any other type of household or
industrial cleaner will cause damage to the unit and should not be used.
2. Clean the top of the unit with isopropyl alcohol and non-abrasive cloth or sponge. Remove all residual glue from the top of the unit.
3. Allow the top surface of the unit to dry completely to ensure a good seal of the replacement label.
4. Install the new control panel label.
CAUTION
DO NOT press directly on the LCD display when applying replacement control panel label otherwise damage to the LCD display may
occur.
5. Press firmly on the perimeter surfaces of the label.
Invacare® Solo2™ Portable Oxygen Concentrator
Domed Buttons
concentrator.
2
Control Panel Label
60
Domed Buttons
Part No 1176122