D10 Front Bezel - IBM eserver pSeries 7311 D10 Service Manual

D10 Front Bezel

Before performing the following procedure, read the "Safety Notices" on page vii.
Removal
To remove the front bezel, do the following:
1. Open the front rack door.
2. Simultaneously press in both bezel-release tabs.
3. Pivoting the bezel from the top, swing the top forward.
4. Pull the bottom of the bezel up, then away from the subsystem chassis. This
releases the two tab hooks located on the bottom of the I/O subsystem chassis.
Front Bezel Replacement
To replace the front bezel, do the following:
1. Open the front rack door.
2. Insert the two tabs located on the bottom edge of the bezel into their locking hooks,
located on the chassis.
3. Pivot the front bezel up toward the top of the chassis.
4. Align the release tabs to the matching slots located on the front of the subsystem
chassis.
5. Gently push the tabs into the slots until the bezel seats against the front of the
subsystem.
6. If the subsystem is not completely in the operating position, push the subsystem
back into the operating position as described in "D10 Operating Position" on
page 57.
7. Close the rack door.
Eserver pSeries 7311 Model D10 and Model D20 Service Guide
58