7311 Model D20 I/O Subsystem Removal And Replacement Procedures; Model D20 Fru Replacement Procedure List - IBM eserver pSeries 7311 D10 Service Manual

7311 Model D20 I/O Subsystem Removal and Replacement Procedures

Notes:
1. All of the parts in the 7311 Model D20 I/O Subsystem can be replaced with the
subsystem installed in a rack. The power supplies, blowers, disk drives and PCI
adapters are hot-plug. Under normal conditions, during the swapping of these
FRUs, there is no need to shut down or unplug the system.
2. Before performing any of the removal or replacement procedures in this chapter,
read the danger and caution notices on "Safety Considerations" on page 53.

Model D20 FRU Replacement Procedure List

Field Replaceable Unit
(FRU)
Adapters
Bezel
Cover
Disk Drives
Disk Drive Backplanes
Disk Drive 12 Pack Cage
Disk Drive Configuration or
Deconfiguration
Blowers
I/O Backplane
Operating Position
Operator Panel
Power Supplies
Power Bulkhead
RIO Bus Adapter
Service Position
Starting the System
Static-Sensitive Devices
Stopping the System
Eserver pSeries 7311 Model D10 and Model D20 Service Guide
124
FRU Procedure Name and Page Location
"D20 PCI Adapters" on page 142
"D20 Front Bezel" on page 129
"D20 Service Access Cover" on page 127
"D20 Hot-Plug Disk Drives" on page 160
"D20 Disk Drive Backplane" on page 167
"D20 Disk Drive Cage" on page 165
"Deconfiguring (Removing) or Configuring a Disk Drive" on
page 160
"D20 Blowers" on page 134
"D20 I/O Backplane" on page 175
"D20 Operating Position" on page 126
"D20 Operator Panel" on page 131
"D20 Power Supplies" on page 169
"D20 Power Supply Bulkhead" on page 172
"D20 RIO Bus Adapter Assembly" on page 139
"D20 Service Position" on page 125
"Starting the System" on page 55
"Handling Static-Sensitive Devices" on page 54
"Stopping the System" on page 55