Leckey Comfee Seat User Instructions page 9

8.3 Fitting the Seat Base
Cushion
Before fitting the seat base cushion, ensure
the calf support cushion has been fitted
first. Insert the foam into the seatbase
cover ensuring the profile of the foam is in
the correct position. Zip to secure. Push
the seatbase cushion towards the rear of
the seat base and secure by pulling tabs
underneath the back of the seat base and
attaching to poppers (a). Press the seatbase
cushion down into position and securing the
front using the Velcro strips on top of the calf
support cushion (b).
B
8.4 Fitting the Flipaway
Chest Lateral Cushions
Slide the flipaway lateral cover over the foam
ensuring the profile of the foam is in the
correct position. The lateral bracket should
slide into the centre section of the foam (a).
Zip to secure from both the top and bottom
of the flipaway lateral cushion (b).
A
8.5 Fitting the 4 Point
Pelvic Belt
Remove seatbase cushion by pulling tabs
away from poppers underneath the rear
of the seat and lifting cushion off Velcro
strips. Feed the 4 pelvic belt straps through
camlock fittings (a) and clamp to secure.
A
B A
8.6 Fitting the Calf
Support Cushion
Slide the calf support cushion over the
foam ensuring the soft sponge side of the
foam is facing the front. Zip cushion to
secure. Locate the 4 poppers on top of
the wooden seat base and attach each tab
(a). Pull the 2 tabs at the bottom of the calf
support cushion and attach to the 2 poppers
underneath the wooden calf support.
A