Leckey Comfee Seat User Instructions page 17

10.8 Padded Footplate
Straps
To remove padded footplate straps, pull
velcro strip away from the strap. To secure
the padded footstrap around the user, pull
the velcro strip tightly and secure to the
strap.
10.9 Flipaway Laterals
To Flipaway the laterals, pull and hold the
knob (a) until the lateral has flipped away.
Release the knob to lock into position.
11 Cleaning & Care
Information
How to Maintain
When cleaning we recommend that you
use only warm water and a non-abrasive
detergent. Never use organic solvents or dry
cleaning fluids.
Upholstery and fabrics
1. Clean and care for your fabric on a regular
basis. Simply vacuum to remove dust
particles and wipe with a damp cloth for
general cleaning.
2. Microfibre cloths are extremely effective
without soap which is helpful as soap can
clog your fabric.
3. The cushion covers can be removed
(except for the armrests, pommel and gables)
and machine washed at 40°C. Line drying is
recommended however they can be tumble
dried at a low temperature. Please remove
foam from the following covers before
washing:
a. Headrest (ensure you remove speakers
before putting into washing machine if
applicable)
b. Chest Laterals
c. Backrest Cushion
d. Seatbase Cushion
e. Padded Calf Support
All other soft upholstery can be placed into
the washing machine intact, after removing
bolts and fastenings. Store these in a safe
place and out of reach of children.
4. All fabrics including non-machine
washable fabrics can also be cleaned
by hand whilst in place. When cleaning,
A
we recommend you use a non-abrasive
detergent.
5. Staining should be removed as quickly
as possible with absorbent cloth, towels or
a sponge. Routine soap and warm water
sponging is effective for ordinary soiling and
minor spills. Be careful not to over wet the
fabric as this will cause the stain to spread.
6. Antiseptic cleaning agents can be used
on more stubborn stains. These may require
a safe solvent such as Isopropyl Alcohol or
Mineral Spirit. Ensure that cleaning products
are fully removed.
Metal and Plastic Components
1. Soap and water or antibacterial spray can
be used for daily cleaning.
2. Do not use solvents to clean plastic or
metal components.
3. Make sure the product is dry before use.
Wooden Components
Check all wooden components regularly to
ensure there are no cracks or splinters.
1. Wipe clean with warm soaping water
followed by a clean water rinse. Do not
use strong detergents, abrasive products,
organic solvents or dry cleaning fluids.
Heavily ingrained soiling may be removed by
scrubbing with a soft brush.