Leckey Comfee Seat User Instructions page 13

9.7 Flipaway Chest
Laterals
To adjust the height of the Flipaway chest
laterals, remove the covers and unscrew the
2 bolts using your Leckey tool (a). Adjust the
bracket to the required position and tighten
bolts to secure. To adjust the width of the
Flipaway laterals, insert your Leckey tool
inside the slots at the rear of the backrest
(b). Loosen the bolts on each lateral bracket,
slide into required position and re-tighten to
secure.
To Flipaway the laterals, pull and hold the
knob until the lateral has flipped away.
Release the knob to lock into position.
Be careful not to nip fingers when using
the flipaway laterals
B
9.8 Pommel
To adjust the pommel, move the calf support
into the 90 deg position for ease of access.
(The calf support can be adjusted to any
position after the pommel is inserted). Locate
the slot at the centre of the seat base,
underneath it you will find a pull pin. Pull the
pin down and slide the pommel into the slot
(a). There are 3 depth options available and
the pommel will click into the closest pre-set
position when you release the pull pin.
A
A
9.9 Tilt in Space
Locate the lever at the rear of the wooden
backrest at the top right (a). Pull to the right
and tilt the seat to the required position.
Release the lever to lock.
9.10 Calf Support
Locate the lever at the left hand side of the
calf support (a). Pull the lever while adjusting
the calf support to the required angle.
Release the lever to lock.
A A