Loading the Thermal Paper
1. Turn on the power.
2. Cut the tip of the thermal paper straight
across. New paper can be inserted as is.
(See figure on right)
3. Open the paper cover.
4. Push the tip of the thermal paper into the inlet at the bottom of the
paper holder, until the auto-loader catches it and feeds about 10cm
of it through the paper cutter.
NOTE
Load the thermal paper in an area protected from direct sunlight.
HINT
•
Place the thermal paper on the cover to make feeding easier.
The printing surface
is the outside of the
thermal paper roll.
Insertion Slot
5. Keep pressing the FEED button until the thermal paper feeds
straight and smoothly.
HINT
•
When the thermal paper is set correctly, the OFFLINE LED stops
blinking and stays on to indicate the printer is still in OFFLINE
mode.
•
When the thermal paper is about to run out, red lines appear on
both sides of the thermal paper.
- 18 -
Paper
Insert
direction