Seiko DPU-414 User Manual page 23

2.3 Setting the Software DIP Switches (SWDIP switch)
The startup settings and input method can be set by the Software DIP
switches (SWDIP switch). Refer to section 2.4, SWDIP Switch Settings,
for details on the different settings.
1. Slide the Power Switch to OFF.
2. Slide the Power Switch to ON while pressing the ONLINE button.
Release the ONLINE button after a list of the current settings starts
printing out.
3. The print out of the current settings is followed by the prompt:
"Continue? :Push 'On-line SW' ",
"Write?: Push 'Paper feed SW' "
To change the SWDIP switch settings, push the ONLINE button,
and move onto step 4.
To leave the SWDIP switch settings unchanged, push the FEED
button, and move onto step 5.
4. 'Dip SW1' is printed prompting the input of new settings for switch
number 1 through 8 of SWDIP switch 1.
NOTE
 Always input either "ON" or "OFF" for every setting in order for
switch number 1 through 8 because SWDIP Switch Set Mode can
not be canceled once it is initiated.
"ON" can be set by pushing the ONLINE button once and "OFF" by
pushing the FEED button once.
The setting is printed out after the ONLINE or FEED button is
pushed to allow to confirm the new setting.
As soon as switch number 8 is set, the printer once again prompts
with "Continue?" or "Write?", and step 3 is repeated for SWDIP
switch 2 and 3.
HINT
• The ONLINE LED lights when the ONLINE button is pressed and
the OFFLINE LED when the FEED button is pressed to allow
confirmation of the button operation.
5. After the FEED button is pushed, the ONLINE and OFFLINE LED
alternately blink and the new settings are written to memory. When
the printer finishes writing everything to memory, "Dip SW setting
- 19 -