Backrest - Etac Wheelchair Manual Manual

7:1 BACKREST

The backrest is adjustable in angle and has adjustable upholstery.
Risk for tipping! Always check the positioning of
the anti-tip when adjusting the backrest.
7:2 Backrest height
The backrest is telescopic and is adjustable between 25-35 cm. Unscrew
the lower screw, (A) and loosen the upper screw one turn on both sides.
Select the desired height. There are attachment points at 2 cm intervals.
Tighten the screws properly.
Tools: 4 mm Allen key; 6 mm Allen key, if required.
7:3 Backrest angle
The backrest angle has fixed positions at +3°, 0°, -3°, -5°, -8° and -10°
Unscrew (A) completely, loosen screws (B) one turn. Install the desired
height by tuning the screw (A) to the correct angle marker. Tighten the
screws again.
Tools: 4 mm Allen key.
(!) Fold the backrest down against the seat when adjusting the
angle.
Allow the backrest cover ample space between seat and
backrest.
Risk of tipping! Always check the positioning of the anti-tip
when adjusting the backrest angle.
7:4 Backrest upholstery
The form of the backrest upholstery can be adjusted by means of four
Velcro straps and the cover.
- Give the backrest cover ample space between the seat and
backrest, allowing the user to "sit in" against the backrest,
- Loosen all straps and ensure that the user is sitting as far back
in the seat as possible.
- Tighten the straps in such a way that they follow the contours
of the user's back and give plenty of support to the lumbar region.
Risk for tipping! Always check the position of the anti-tip after
adjusting the backrest upholstery.
7 SETTINGS BACKREST
14
B
A C