Backrest - Etac Transit lll Manual

8:1 Backrest angle
The angle can be set in the fixed
positions -6°, -3°, 0°, +3° and +6°.
Loosen nut (A), remove the screw and
set at required angle, retighten the nut.
8:2 Backrest height
The backrest is adjustable to a height
of 40, 42.5, 45 and 47,5 cm. Undo
the screws (A). Pull the backrest
upholstery upwards. Unscrew the nuts
(B) and adjust to the desired height.
Make sure that both sides have the
same height.
8:3 Backrest height for vertically adjustable push handles (option)
The backrest is adjustable to a height
of 40, 42.5 and 45 cm.
Undo the screws (A). Remove the
push handle attachment.
Unscrew the screws (B) and adjust
to the desired height. Make sure that
both sides have the same height.
8:4 Backrest upholstery (option)
The form of the backrest upholstery is
individually adjustable by means of five
Velcro straps and the backrest cover.
- Give the backrest cover ample
space between the seat and
backrest, allowing the user to "sit
in" against the backrest.
- Loosen all straps and ensure that
the user is sitting as far back in
the seat as possible.
- Tighten the straps in such a way
that they follow the contours of
8 Backrest settings
Tools: 10 mm ring spanner
Tools: 3 mm Allen key,
8 mm ring spanner.
Tools: 3 mm, 5 mm
Allen key, 8 mm
ring spanner
the user's back and give plenty of
support to the lumbar region.
Risk of tipping: Always
check the position of the
anti-tips when adjusting
the backrest upholstery.
(!) Do not overtighten the upper
straps as this can prevent
the cross-brace from unfolding
properly, i.e. the seat-frame tubes
do not sit flush in the sideframes.
13
+6°
A
0
6
-3
3
-6
A
B
A
-6°
B