Chesney's Wood Burning and Multi Fuel Stoves User's Installation Manual page 29

Operation with door left open
Operation with the door open can cause excess smoke. The appliance
must not be operated with the appliance door left open except as directed
in the instructions.
Refuelling
Always refuel on a hot bed of ash.
Pull Air Flow Bar fully out to setting III. Slowly open the door with the glove
provided equalising the pressure inside the fire cube with the room (if you
open the door quickly ash will be lifted from the furnace into the room).
Place 2-3 logs bark side down onto a bed of hot ashes and close the door.
When the logs have fully turned black set Air Flow Bar to desired setting.
Solid Fuel
The grate should be cleaned out before every lighting using the riddle lever.
Set fuel selector to solid fuel (forward position).
Open door, place 2 firelighters at the back of the fire cube and place
approximately 1 – 1.5kg of solid fuel onto the firelighter and set the Air Flow
Bar to setting III fully extended. Light firelighter and close door, if
condensation appears on the glass when the door is closed leave ajar. Do
not leave stove unattended when the door is open.
The majority of air for combustion in the coal setting comes from under the
grate below the fuel. This action reduces the ability of the air wash system
and some blackening of the glass may occur.
When the solid fuel has an even glow over the fuel bed set Air Flow Bar to
desired setting.
29