Download Print this page

Chesney's Opti-Myst User Manual

Electric fire basket & electric stove
Hide thumbs Also See for Opti-Myst:

Advertisement

1
CHESNEY'S
powered by
Electric Fire Basket &
Electric Stove User Manual
Issue 04

Advertisement

loading

Summary of Contents for Chesney's Opti-Myst

  • Page 1 CHESNEY’S powered by Electric Fire Basket & Electric Stove User Manual Issue 04...
  • Page 2 Thank you for choosing this Chesney’s electric fire. Please read this information guide carefully to be able to safely install, use and maintain your product. Front cover upper image shows Chesney’s Electric Fire with Universal Basket and Spherical Fire Dogs. Lower image shows the Beaumont Electric Stove in yellow paint finish...
  • Page 3: Table Of Contents

    CHESNEY’S powered by Contents 1. Important Safety Advice 2. General Information 3. Installation Instructions 4. Operating the Fire 5. Maintenance 6. Troubleshooting 7. Additional Information 8. Warranty Registration...
  • Page 4: Important Safety Advice

    1. Important Safety Advice WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK AND INJURY TO PERSONS, INCLUDING THE FOLLOWING: 1. OVERHEATING WARNING: IN ORDER TO AVOID OVERHEATING, DO NOT COVER THE HEATER. DO NOT PLACE MATERIAL OR GARMENTS ON, OR OBSTRUCT THE AIR CIRCULATION AROUND THE APPLIANCE.
  • Page 5 AUTOMATICALLY, SINCE A FIRE RISK EXISTS WHEN THE HEATER IS ACCIDENTALLY COVERED OR DISPLACED. 6. UNPLUGGING IN THE EVENT OF A FAULT UNPLUG THE DEVICE. UNPLUG THE DEVICE WHEN NOT REQUIRED FOR LONG PERIODS. 7. OWNER/USER THIS APPLIANCE CAN BE USED BY CHILDREN AGED FORM 8 YEARS AND ABOVE AND PERSONS WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES OR LACK OF EXPERIENCE AND KNOWLEDGE IF THEY HAVE BEEN...
  • Page 6: General Information

    2. General Information Only use filtered water in this appliance. This model is designed to be free standing and is normally positioned near a wall, on a non combustible surface. Always ensure the appliance is sitting on a level, non-combustible surface.
  • Page 7: Installation Instructions

    3. Installation Instructions This section describes how to set up your fire. BEFORE YOU START 1. Ensure that all packing items are removed (read any warning labels carefully) and retain all packing for possible future use e.g. in the event of moving house or returning the appliance to your supplier.
  • Page 8 Filling the Water Tank 9. Place Water Tank in sink and remove cap (turn anti-clockwise to open) (Fig 7). 10. Fill Water Tank with filtered tap water only. This is necessary to pro- long the life of the flame and smoke effect producing unit. The water should be filtered through a conventional domestic water filter unit and the filter should be replaced regularly.
  • Page 9: Operating The Fire

    4. Operating the Fire This section describes how to activate your fire using either the manual controls or remote control. MANUAL CONTROLS The manual controls are located beneath the hinged flap. (See Fig.9 for Manual Control lay out). Switch ‘A’:- Controls the electricity supply to the Fire. Note: This switch must be in the ‘ON’...
  • Page 10 SETTING THE THERMOSTAT (Electric Stove models only) Ensure the fire is plugged in and switch it on to the full heat setting. Turn the Control Knob ‘C’ fully to the right (max temperature setting) to warm the room rapidly. When the room temperature has reached the desired level, turn the thermostat knob back slowly until you hear the thermostat just click off.
  • Page 11 REMOTE CONTROL OPERATION On the control panel, Switch A (see Fig. 9) must be in the ‘ON’ ( I ) position in order for the remote control to operate. There are 3 buttons on the remote control. (See Fig.11) To operate correctly the remote must be pointed towards the front of the grate.
  • Page 12: Maintenance

    5. Maintenance GENERAL TIPS Only use filtered tap water in this appliance. Always ensure that the appliance is sitting on a level surface. If you intend not using the appliance for longer than 2 weeks, remove and empty the sump and water tank. Once installed, never move this appliance or lay on its back, without draining the water from sump and water tank.
  • Page 13 4. Leave the appliance for 20 minutes to allow the lamps to cool down before removing them. 5. Remove the sump as described in the Cleaning Section. 6. Remove the defective lamp, by gently lifting vertically and disengaging the pins from the lamp holder, (See Fig.3 and 4).
  • Page 14 5. Release the right sump locking tabs by turning 90º. This allows the sump to be lifted completely from its location. 6. Gently lift up the sump, taking care to keep level so as not to spill any water. Sit the assembly in the sink. 7.
  • Page 15 Fig.1 Fig.2 Fig.3 Fig.4...
  • Page 16 Fig.5 Fig.5a Fig.6 Fig.5b...
  • Page 17 Fig.7 Fig.8 Fig.9 (Electric Stove models)
  • Page 18 Fig.11 Fig.10 Fig.13 Fig.12...
  • Page 19 Fig.14 Fig.15...
  • Page 20 Fig.16 REMOTE CONTROL SENSOR Electric Fire Basket (model shown: Universal Freestanding Basket) Electric Stove (model shown: Salisbury) REMOTE CONTROL SENSOR...
  • Page 21 Use the fixing chain provided to secure the appliance to a rear wall...
  • Page 22: Troubleshooting

    6. Troubleshooting SYMPTOM CAUSE CORRECTIVE ACTION The flame effect Mains plug is not Check plug is connected to will not start. plugged in. wall socket correctly. Low water level. Check that the water tank is full and there is water in the sump.
  • Page 23 SYMPTOM CAUSE CORRECTIVE ACTION Unpleasant Dirty or stale water. Clean the unit as described smell when unit under maintenance. is used. Using unfiltered tap Use only filtered tap water. water. The flame effect Flame effect setting is Turn the flame effect Control has too much too high.
  • Page 24: Additional Information

    New Zealand NZ 571900 © Chesney’s MMXIV March 2014 Opti-myst is a trade mark of GDC Group Ltd. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Chesney’s.
  • Page 25 - Notes -...
  • Page 26 - Notes -...
  • Page 27: Warranty Registration

    8. Warranty Registration To validate and start your warranty please fill out this form and send it back to: Chesney’s Warranty Registration, 521 Battersea Park Road, London, SW11 3BN Alternatively, log on to: www.chesneys.co.uk/warranty/registration.asp and complete the online form. All items are required: Your Details Name Address...