Apollo 4 & 8 Installation - Chesney's Wood Burning and Multi Fuel Stoves User's Installation Manual

The Apollo range of inset stoves have been designed to be installed in two
stages. The outer casing needs to be installed before the fire cube, and the
outer frame and door will need to be removed to install this appliance.
1) Remove all internal parts (baffles, side and rear bricks, solid
fuel grate and ash pan (8 series only).
2) Remove the frame which is secured with four hexagonal bolts
under the top edge circled below (figure 3).
3) To remove the door you must release the door retaining bar
before lifting off the hinges.
4) The flue collar retaining bolts are now visible; remove these
and the flue collar will drop down inside the fire cube.
5) Remove the fire cube retaining bolts (circled figure 2).
Figure 2
6) Remove the four transport bolts in the rear of the outer casing.
The fire cube can now be removed.
7) If in a Smoke Control Zone remove "Smoke Tab"
8) Instal the outer casing. There are eight available securing
points for the outer casing four in the base and four in the rear
a minimum of four points must be used.
7. Apollo 4 and 8 Installation
Figure 3
17