quiko QK-H300 User & Installation Manual page 6

QK-H300
α = 90°
B (mm)
A (mm)
min max
100 120 170
110 120 170
140 120 150
L MAX (mm) 1010
4- Temporary fix the actuator to the wall and to the leaf (tack weld) and turn the
leaf gate from the close position up to the max. open position (normally 95° ) and
check that the leaf turn freely in the hinges and without any swing during its
movement.
5- Provide to complete the assembly of the actuator to the wall and to gate leaf.
6- Connect to the power supply cable 4x1,5 sqmm
7- Proceed with the control board programming (see the CONTROL BOARD
USER MANUAL )
Adjust the actuator thrust acting with the screwdriver on the by pass valves #14
α = 95° °
B (mm)
A (mm)
min max
120 130 170
130 130 170
Fig 3
QK-H400
α = 90°
B (mm)
A (mm)
min max
110 120 250
120 120 250
150 120 250
200 120 190
210 120 190
220 120 180
230 120 160
Table 1
α = 95°
B (mm)
A (mm)
min max
120 120 220
130 120 220
160 120 210
210 120 160
220 120 160
230 120 130
240 120 120