Program Values - Bosch Integra 500 Installation Manual

Maintenance and service
Fig. 64 Adjusting P2 CO
Program Description
P1 Maximum Power
P2 Minimum Power
P3 Remote
Controls installed
P4 Access to
Diagnostic Mode
P5 Cascade Mode
P6 Temperature Unit
P7 Appliance Type
P8 Back light
P9 Fan Purge
Table 18 Program values, factory default settings and ranges.
* Incorrect setting causes errors.
38
6720608158-38.1AL
level
2
Factory Default
NG: 51,
LP: 51
12
_0
E
NO
°F
Cd
dE
6.6

Program values

This section describes details on programming the
appliance. For most applications the factory default
values will provide robust and stable operation. Only
adjust the factory settings if the installation requires
changes as indicated in the appropriate section of this
manual.
Refer to 6.7 Control board diagnostics (page 35)
regarding how to access these P-modes.
Caution:
values can
malfunction, errors, and service
calls.
MIN MAX
21 NG: 53,
LP: 53
12 20
_0 6
0d 10f
NO CC
°F °C
Cd NO
dE ON
Misadjusted program
lead to appliance
Comment
see chapter 3.13, page 28
note: reducing P1 values below
maximum will reduce maximum
power of the appliance.
see chapter 3.3.6, page 16
see chapter 5.5, page 32
see chapter 6.7, page 39
contact Bosch for details
Condensing / Non-condensing
note: incorrect setting will cause
errors.
dE turns back light off after 60
seconds from last button pushed,
ON turns backlight
permanently
runs secondary fan and primary
fan when P9 is selected by
depressing the "P" - button
6 720 680 226
on