Razberi DV200 User Manual page 56

Upload Image by E-Mail

Select this item and the Administrator can assign an e-mail address and
configure various parameters. When tampering is detected, event
images will be sent to the appointed e-mail address.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after tampering occurs.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of
the duration will be uploading by E-mail when tampering is triggered.
The setting range is from 1 to 9999 seconds. Select <Upload during the
trigger active> to make the images keep being upload to E-mail during
the trigger active until tampering stops. Set the Image frequency as the
upload frame rate. The setting range is from 1 frame to 20 frames.
NOTE: Make sure SMTP configuration has been completed.
Refer to
Send HTTP notification

Check this item, select the destination HTTP address, and specify the
parameters for HTTP notifications. When the Tampering Alarm is
triggered, the HTTP notifications can be sent to the specified HTTP
server.
For instance, if the custom parameter is set as" action=1&group=2", and
the HTTP server name is" http://192.168.0.1/admin.php", the notification
will be sent to HTTP server as"
action=1&group=2" when alarm is triggered.
File Name
The uploaded image's filename format can be set in this section. Please select
the one that meets your requirements.
Mail for further details.
http://192.168.0.1/admin.php?
razberi technologies™
55