Razberi DV200 User Manual page 45

Upload Image by E-Mail

Select this item and the Administrator can assign an e-mail address and
configure various parameters. When the alarm input is triggered, event
images will be sent to the appointed e-mail address.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after alarm input is triggered.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of
the duration will be uploading by E-mail when the alarm input is
triggered. The setting range is from 1 to 9999 seconds. Select <Upload
during the trigger active> to make the images keep being uploaded to
E-mail during the trigger active until the alarm is released. Set the Image
frequency as the upload frame rate. The setting range is from 1 frame to
15 frames.
Send HTTP notification

Check this item, select the destination HTTP address, and specify the
parameters for event notifications by <Alarm> triggered. When an alarm
is triggered, the notification can be sent to the specified HTTP server.
For instance, if the custom parameter is set as" action=1&group=2", and
the HTTP server name is" http://192.168.0.1/admin.php", the notification
will be sent to HTTP server as"
action=1&group=2" when alarm is triggered.
44
NOTE: Please make sure the local recording (with Micro SD/
SDHC card) is activated so that this function can be
implemented. Refer to
NOTE: Make sure SMTP configuration has been completed.
Refer to Mail for further details.
Recording for further details.
http://192.168.0.1/admin.php?
razberi technologies™