Razberi DV200 User Manual page 50

Record stream to SD Card

Select this item and the Motion Detection recording will be stored in
Micro SD/ SDHC card when motion is detected.
Pre-trigger buffer recording function allows users to check what
happened to cause the trigger. The pre-trigger buffer time range is from
1 to 3 seconds.
Select <Upload for __ sec> to set the recording duration after motion
event occurs. The setting range is from 1 to 99999 seconds.
Select <Upload during the trigger active> to record the triggered video
until the trigger is off.
NOTE: Please make sure the local recording (with Micro SD/
SDHC card) is activated so that this function can be
implemented. Refer to
Send Alarm Message by FTP/E-Mail

The Administrator can select whether to send warning messages by
FTP and/or E-Mail when motion is detected.
Upload Image by FTP

Select this item and the Administrator can assign a FTP site and
configure various parameters. When motion is detected, event images
will be uploaded to the appointed FTP site.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after motion event occurs.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of
the duration will be uploaded to FTP when the motion event occurs. The
setting range is from 1 to 9999 seconds. Select <Upload during the
trigger active> to make the images keep being uploaded to FTP during
Recording for further details.
49
razberi technologies™