Razberi DV200 User Manual page 55

Select <Upload for __ sec> to set the recording duration after tampering
occurs. The setting range is from 1 to 99999 seconds.
Select <Upload during the trigger active> to record the triggered video
until the trigger is off.
Send Alarm Message by FTP/E-Mail

The Administrator can select whether to send an alarm message by FTP
and/or E-Mail when tampering is detected.
Upload Image by FTP

Select this item and the Administrator can assign a FTP site and
configure various parameters. When tampering is detected, event
images will be uploaded to the appointed FTP site.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after tampering is triggered.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of
the duration will be uploaded to FTP when tampering is triggered. The
setting range is from 1 to 9999 seconds. Select <Upload during the
trigger active> to make the images keep being upload to FTP during the
trigger active until the tampering stops. Set the Image frequency as the
upload frame rate. The setting range is from 1 frame to 15 frames.
54
NOTE: Please make sure the local recording (with Micro SD/
SDHC card) is activated so that this function can be
implemented. Refer to
NOTE: Make sure FTP configuration has been completed. Refer
to FTP for further details.
Recording for further details.
razberi technologies™