Razberi DV200 User Manual page 51

the trigger active until the event stops. Set the Image frequency as the
upload frame rate. The setting range is from 1 frame to 15 frames.
Upload Image by E-Mail

Select this item and the Administrator can assign an e-mail address and
configure various parameters. When motion is detected, event images
will be sent to the appointed e-mail address.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after the motion event occurs.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of
the duration will be uploading by E-mail when the motion event occurs.
The setting range is from 1 to 9999 seconds. Select <Upload during the
trigger active> to make the images keep being uploaded to E-mail
during the trigger active until the event stops. Set the Image frequency
as the upload frame rate. The setting range is from 1 frame to 15
frames.
Send HTTP notification

Check this item, select the destination HTTP address, and specify the
parameters for event notifications by <Motion Detection> triggered.
When an alarm is triggered, the notification can be sent to the specified
HTTP server.
For instance, if the custom parameter is set as" action=1&group=2", and
the HTTP server name is" http://192.168.0.1/admin.php", the notification
50
NOTE: Make sure FTP configuration has been completed. Refer
to FTP for further details.
NOTE: Make sure SMTP configuration has been completed.
Refer to Mail for further details.
razberi technologies™