In-Bed Mount - Fisher speed-caser 2 Owner's Manual

MOUNTING THE SPREADER
5.
In-Bed Mount Lift the hopper assembly using a hoist or two
people, and tip slightly forward.
1
Remove the tailgate from the vehicle
2. Place the mount assembly into the bed of the
vehicle.
3. Slide the assembly forward engaging the locator
studs.
6. Position the tabs of the hopper assembly over the
top of the mount assembly, and lower.
4. Secure the front of the mount assembly to the
channel using hold-down bolts. Hand tighten.
7. Allow the hopper assembly to lower into position.
NOTE: Apply a small amount of grease to the bolt
thread periodically to ensure easy removal.
November 1998
6 Form No.13722