Table of Contents
Advertisement
CAUTION
Before drilling holes, check to be sure that no
vehicle wiring or other components could be
damaged.
4. Drill four holes in the hopper using the
support frame holes as a template. Place the
backing plate inside the hopper.
5. Fasten the hopper to the support frame by running
the four supplied 5/16" x 1" cap screws through
the backing plate, hopper, and support frame from
inside the hopper. Attach using the four supplied
5/16" locknuts. Tighten the fasteners according to
the torque chart.
Lit. No. 43755/43757, Rev. 04
www.storksplows.com
MOUNTING THE SPREADER
Hopper
5/16"
Locknut
5/16" x 1" Cap Screw
13
RECEIVER MOUNT SPREADER
CAUTION
During removal or mounting, securely grip
spreader to avoid dropping.
The spreader shall be installed according to
instructions supplied. Your local outlet is trained to
provide this service and service your spreader with
factory original parts.
Insert the assembled unit into the receiver hitch and
secure with the supplied hitch pin and hairpin cotter.
Hairpin Cotter
Receiver Mount
Hitch Pin
Receiver Hitch
December 15, 2020
Advertisement
Table of Contents
