Page 1
Owner's Manual and Installation Instructions Original Instructions CAUTION Read this document before operating or servicing the spreader. This document is for FISHER WB-100B walk-behind broadcast spreaders ® with serial numbers beginning with 0000 and higher. This document supersedes all editions with an earlier date.
Page 2
Lit. No. 43577/43587/43597, Rev. 02 February 1, 2019...
PREFACE This manual has been prepared to acquaint you with When service is necessary, bring your walk-behind the safety information, operation, and maintenance spreader to your distributor. They know your spreader of your new walk-behind spreader. Please read this best and are interested in your complete satisfaction. manual carefully and follow all recommendations.
SAFETY SAFETY DEFINITIONS LABELS Please become familiar with the labels on the WARNING spreader. Indicates a potentially hazardous situation that, if not avoided, could result in death or NOTE: If labels are missing or cannot be read, see serious personal injury. your sales outlet.
Page 7
SAFETY SAFETY PRECAUTIONS NOTE: Lubricate grease fi ttings after each use. Use a good quality multipurpose grease. Improper installation and operation could cause personal injury and/or equipment and property PERSONAL SAFETY damage. Read and understand labels and this Owner's Manual before assembling, operating, or •...
LOADING LOADING YOUR SPREADER WARNING Never remove spreader from vehicle with WARNING material in it as this could cause damage to the frame assembly. Do not overload spreader. Use chart below to calculate weight of material. Weights of material are an average for dry materials. CAUTION DO NOT leave unused material in Material Weights...
ASSEMBLY ASSEMBLING YOUR SPREADER 5. Slide the handle assembly on to the frame stand and fasten with two 1/4" x 1-3/8" cap screws and WARNING 1/4" locknuts. Use safety glasses and gloves when infl ating Handle and installing the tires. Use manual pump Assembly only to infl...
Page 10
ASSEMBLY 6. Insert the gate actuator rod end into the gate cam Spin the tires and make sure the spreader is and secure with a hairpin cotter. running smoothly. 8. Tighten all fasteners. 9. Place the screen inside the hopper and put the hopper cover on.
Page 11
MAINTENANCE LUBRICATION To keep your spreader running smoothly, observe the following recommendations: Remove the gear housing and apply chain lube spray lubricant. Luricate both fittings with a good quality multipurpose grease. NOTE: Gears and axles must be lubricated and greased every 20 hours of use. Lit.
Page 12
Fisher Engineering reserves the right under its product improvement policy to change construction or design details and furnish equipment when so altered without reference to illustrations or specifi cations used. Fisher Engineering offers a limited warranty for all spreaders and accessories.
Need help?
Do you have a question about the WB-100B and is the answer not in the manual?
Questions and answers