REMOVING
THE SPREADER
In-bed Mount
4.
Using a hoist or two people, tip the hopper
assembly forward and lift it off of the mount
assembly.
NOTE: Empty the hopper before removing
the
spreader.
1
Disconnect the spreader wiring harness from the
vehicle wiring harness.
5.
Loosen and remove the hold-down bolts from the
front of the mount assembly.
NOTE: Grease the electrical
connections
using
dielectric
grease.
2.
Install the plug cover overthe vehicle harness plug.
3.
Remove the hairpin cotter pins and hold-down pins.
6.
Remove the mount assembly from the vehicle.
7.
Install the tailgate.
November 1998
12
Form No.13722