SECTION 11—WHEELS AND SHROUDS
SECTION 11—WHEELS AND
SHROUDS
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
Replacing the Flat Free Tires on the Wheel Rim
DO NOT attempt to replace flat free tires. This procedure MUST be performed by
a qualified technician.
NOTE: During initial use of the wheelchair, the user may experience flat spots on the wheels. Flat
spots will vanish with continued use of the wheelchair.
Removing/Installing the Top Shroud
Wheelchairs without Elevating Seat
NOTE: For this procedure, refer to
FIGURE 11.1.
NOTE: Reverse this procedure to install the top
shrouds
1. Remove or tilt the seat back. Refer to
Removing/Installing or Tilting the Seat
Assembly on page 46.
2. Remove the two thumb screws
securing the rear half of the top shroud
to the wheelchair fame.
3. Pulling up, remove the rear half of the
top shroud.
4. Remove the two thumb screws
securing the front half of the top
shroud to the wheelchair fame.
5. Pulling up, remove the front half of the
top shroud.
TDX® SC TDX® Spree
WARNING
WARNING
Thumb
Screws
Front Half of
Top Shroud
FIGURE 11.1 Removing/Installing the Top
Shroud - Wheelchairs without Elevating Seat
54
Rear Half of
Top Shroud
Thumb
Screws
Wheelchair
Frame
Part No 1149267