Remote On/Off Switch; Mode Switch; Memory Card Slot - Invacare TDX SC Operator And Maintenance Manual

SECTION 5—WHEELCHAIR OPERATION

Remote On/Off Switch

The remote On/Off switch input is located at the rear of the joystick on the right side and
allows the power switch to be operated by an ability switch (normally open momentary
switch with mono plug). To use the remote On/Off feature, the Drive Select/On/Off switch
must be in the On position. Each activation of the ability switch will alternately turn the
joystick On or Off.

Mode Switch

NOTE: For this procedure, refer to FIGURE 5.4 on page 38.
The mode switch is used to select the operating mode for the wheelchair. The mode
switch is located on the joystick. A mode switch is needed whenever any of the following
operating modes are programmed:
• Environmental Controls (ECU 1, ECU 2, ECU 3, ECU 4)*
• 3 Speed Mode in Digital 3 Speed (Slow, Medium, Full)
• Latched Modes
• Sleep Mode
• RIM Mode*
• Remote Drive Selection Mode*
• Tilt/Recline Mode*
• Information Center Display Selection (does not require Reset activation at power up)
If any of the above modes are selected, the control will require activation of the switch
immediately after the power switch is turned On in order to enter the drive mode. The
second line of the LCD will display ‐ PRESS RESET.
*NOTE: In these modes, Standby Select allows the reset switch to be bypassed for users unable to
activate the switch.

Memory Card Slot

The memory card slot is used with the basic or professional memory card for saving or
reading wheelchair parameters.
42
TDX® SC TDX® Spree Part No 1149267