Candy COS 125 D User Instructions page 66

EN
Ensure that the water inlet
tap is turned on.
And that the discharge
tube is in place.
PROGRAMME SELECTION
Refer to the programme guide
to select the most suitable
programme.
Turning the selector knob
required programme is
activate.
The display will show the
settings for the programme
selected.
Adjust the wash temperature if
necessary.
Press the option buttons (if
required)
Then press the START button.
When the START button is
pressed the machine sets the
working sequence in motion.
The programme carries out
with the programme selector
stationary on the selected
programme till cycle ends.
Warning: If there is any break
in the power supply while the
machine is operating, a
special memory stores the
selected programme
and,when the power is
restored, it continues where it
left off.
When the programme has
ended the word "End" will
appear on the display
Wait for the door lock to be
released (about 2 minutes
after the programme has
finished).
Switch off the machine by
turning the programme
selector to the "OFF" position.
Open the door and remove
the laundry.
FOR ALL TYPES OF
WASH CONSULT THE
PROGRAMME TABLE
AND FOLLOW THE
OPERATIONS IN THE
ORDER INDICATED.
66
SL
Prepriãajte se, da je pipa
za dotok vode odprta.
Preverite, da je cev za
odtok vode pravilno
name‰ãena.
IZBIRANJE PROGRAMOV
Upo‰tevajte navodila v
razpredelnici programov in
izberite najustreznej‰i
program. Obrnite gumb
programatorja na izbrani
program.
Na prikazovalniku so vidne
nastavitve za izbrani
program.
Po potrebi prilagodite
temperature pranja.
Po potrebi izberite opcije s
pomoãjo ustreznih tipk.
Nato pritisnite na tipko START;
stroj zaãne izvajati program.
Gumb programatorja se med
izvajanjem programa ne
obraãa.
Opozorilo: âe med
delovanjem stroja zmanjka
elektriãne energije, se izbrani
program shrani v spomin in ko
je stroj spet pod napetostjo,
nadaljuje z izvajanjem
programa.
Ko je program zakljuãen, se
na prikazovalniku prikaÏe
napis "End" (Konec).
Ko je program zakljuãen,
poãakajte pribl. 2 minuti, da
se sprosti zapah vrat.
Izklopite stroj z obraãanjem
gumba programatorja na
OFF.
Odprite vrata stroja in
poberite perilo iz bobna.
PRED IZBIRO PROGRAMA
ZA PRANJE POSAMEZNIH
VRST PERILA PREGLEJTE
RAZPREDELNICO
PROGRAMOV TER
UPO·TEVAJTE ZGORAJ
NAVEDENI VRSTNI RED
OPRAVIL.