Candy COS 125 D User Instructions page 30

EN
"WASH TEMPERATURE" BUTTON
The Wash Temperature button
allows a reduction in the
wash temperature in each
programme.
Each time the button is
pressed the temperature
decreases until a minimum of
15°C (cold Wash
"DELAY START" BUTTON
This button allows you to pre-
programme the wash cycle
to delay the start of the cycle
for up to 24 hours.
To delay the start use the
following procedure:
Set the required programme.
Press the button once to
activate it (h00 appears on
the display) and then press it
again to set a 1 hour delay
(h01 appears on the display);
the pre-set delay increases
by 1 hour each time the
button is pressed, until h24
appears on the display, at
which point pressing the
button again will reset the
delay start to zero.
Confirm by pressing the
"START/PAUSE" button (the
light on the display starts to
flash). The countdown will
begin and when it has
finished the programme will
start automatically.
It is possible to cancel the
delay start by taking the
following action:
Press and hold the button for
5 seconds until the display will
show the settings for the
programme selected.
At this stage it is possible to
start the programme
previously selected by
pressing the "START/PAUSE"
button or to cancel the
process by setting the
selector to the OFF position
and then selecting another
programme.
30
TIPKA ZA TEMPERATURA
PRANJA
Ta tipka omogoãa
zniÏevanje temperature
pranja za posamezne
programe.
Ob vsakem pritisku na tipko
se temperatura zniÏa, in
).
sicer do 15°C (pranje s
hladno vodo
TIPKA ZAMIK VKLOPA
S pomoãjo te tipke lahko
programirate ãasovni zamik
zaãetka programa za najveã
24 ur.
To storite na naslednji naãin:
Izberite ustrezen program.
Enkrat pritisnite na tipko, da
jo aktivirate (na
prikazovalniku se prikaÏe
vrednost h00), nato pa znova
pritisnite na isto tipko, da
nastavite 1-urni zamik (na
prikazovalniku se prikaÏe
vrednost h01). Ob vsakem
pritisku na tipko se vrednost
poveãa za 1 uro. Ko je na
prikazovalniku prikazana
vrednost h24, s ponovnim
pritiskom na tipko prekliãete
ãasovni zamik – spet se
prikaÏe vrednost h00.
Potrdite nastavitev s pritiskom
na tipko "START/PAUSE"
(Start/pavza) – luãka v
prikazovalniku zaãne utripati.
Zaãne se od‰tevanje
nastavljenega ãasa; ko ta
poteãe, zaãne stroj
samodejno izvajati program.
âe Ïelite preklicati nastavljeni
ãasovni zamik:
5 sekund pritiskajte na tipko
za nastavljanje ãasovnega
zamika, dokler se na
prikazovalniku ne prikaÏejo
nastavitve izbranega
programa.
Zdaj lahko takoj zaÏenete
izbrani program s pritiskom
na tipko "START/PAUSE"
(Start/pavza), ali pa
prekliãete postopek izbiranja
z obraãanjem gumba za
izbiranje programov na
poloÏaj "OFF" (Izklopljeno).
Nato lahko izberete drugi
program.
SL
).
E
F