Table of Contents
Advertisement
:
User's Manual
Black Opal Models RMU
Flat Panel Display Systems
6.4.7 Shut-down
•
Press the On/Off button for approx. 3 seconds to set the unit to standby.
•
Switch off external power to the unit.
6.5
Special Functions & Modes
Special functions are available to the user, accessed during the boot-up sequence.
They are:
Boot Sequence Customisation, where the initial backlight level, and the
presentation of the boot logo and of version data may be altered;
EEPROM Recovery, to be used in the case where lay-outs have become
corrupted; and
"Demo" Mode, which runs a sequence of patterns and features for test
purposes and for when an automatic demonstration of system features is
desired.
To access these, the appropriate buttons must be pressed at appropriate times
during the boot-up sequence, as set out in the following table.
PARAMETER
Default
Ramp-up
Backlight
Bright
Level:
Low
Custom (fixed)
Boot Logo Toggle On/Off
Version Info. Toggle On/Off
Log Info. Toggle On/Off
UM-RMU-M-0288-0_1
BUTTON:
1
2
3
4
5
Boot Sequence Customisation
3
3
3 3
3
3
3
20.10.05
TW/TW
WHEN
-
+
3
press and hold from
power on until red
3
LED turns on, then
release
3
3
3
3
3
NOTES
there is only one
opportunity to change
settings on each
power-up, so all of the
desired changes need
to be done in one
operation to avoid
having to start up
again for each
change; choose the
desired settings
before power up, and
press & hold ALL
applicable buttons
simultaneously
Page 6-15
Advertisement
Chapters
Table of Contents
