:
User's Manual
Black Opal Models RMU
Flat Panel Display Systems
6.4.6.2.1 Correct Native VGA Image for Contrast, Brightness and/or Phase
•
From the VGA menu, select GAIN (to adjust display contrast), OFFSET (to
adjust display brightness, as opposed to backlight intensity) or PHASE as
required.
•
Set value(s) as required.
6.4.6.2.2 Correct Native VGA Image for Position and/or Frequency
•
From the VGA menu, select POSITION.
•
Select HORIZ, VERT or FREQUENCY as required.
•
Set value(s) as required.
6.4.6.3 Restore Set-up Defaults
•
If a Main menu is offered, select DEFAULTS (in the case of full-screen VGA or
VIDEO only, the Defaults menu is offered under the Video and VGA menus).
•
From the Defaults menu, select CURRENT.
6.4.6.4 Reboot the System
NOTE:
this function is the same as turning the system off and then
on again using the On/Off button. It is used during software
maintenance activities.
•
From the Defaults menu, select REBOOT.
6.4.6.5 Set the System to Standby
NOTE:
this function is the same as turning the system off using the
On/Off button. It is used during software maintenance
activities.
•
From the Defaults menu, select STANDBY.
UM-RMU-M-0288-0_1
20.10.05
TW/TW
Page 6-14