Perkins 1106C Genset Operation And Maintenance Manual page 78

78
Maintenance Section
Fuel System Primary Filter (Water Separator) Element - Replace
Illustration 54
Typical example
7. Use a suitable tool in order to remove the old
canister (4).
g01370724
Illustration 55
Typical example
8. Lubricate the O ring seal (5 ) with clean engine oil
on the new canister. Install the new canister (6).
Spin on the canister until the O ring seal contacts
the sealing surface. Then rotate the canister 360
degree in order to tighten the canister correctly.
9. Remove the cap (8) from the threaded end of the
new canister and remove the new O ring seal (7).
Install the new O ring seal into the bowl (3).
10. Lubricate the O ring seal (7) with clean engine oil.
Install the bowl onto the new canister. Tighten the
bowl to 15 N·m (11 lb ft).
11. If equipped, install the wiring harness to the
sensor. Open the fuel supply valve.
12. Remove the container and dispose of the fluid in
a safe place.
13. The secondary filter must be replaced at the same
time as the primary filter. Refer to the Operation
and Maintenance Manual , "Fuel System Filter -
Replace".
SEBU8387
g01371107