Securing Liner To Chimney Ring; Outside Air Installation - Quadra-Fire 4100I-GD-B Manual

Wood insert advanced combustion technology (act)

Hide thumbs Also See for 4100I-GD-B:

User manual (40 pages)

Table Of Contents

Table of Contents

There are two options to secure the liner to the chim-

ney ring: See Figure 13A.

Option One: If there is enough room on the top of the

insert to work, hand bend the two tabs upward 90°.

Secure the liner with the supplied hex head bolts 1/4-

20-3/4.

Option Two: Remove the manifold tubes, ﬁ berboard

bafﬂ e and ceramic blanket. From inside the ﬁ rebox,

pull liner down through the chimney ring below the

outer skin. There are two pre-drilled holes in the chim-

ney ring 180° apart. Secure the liner with the supplied

hex head bolts 1/4-20-3/4.

NOTE: Tabs are shipped from factory in a ﬂ at position.

Bend upwards 90 degrees.

IMPORTANT!

THE ZERO CLEARANCE

FIREPLACE OUTSIDE

AIR MUST BE TURNED

TO "ON"

Tools Needed: Phillips Head Screwdriver

1. Remove three screws and cover plate from back side of insert. Save the screws.

2. Re-attach the cover plate using the same screws to front side of the insert as shown in Figure 13B.

3. Repeat same procedure for other side of insert.

NOTE: This insert requires replacement of combustion air. If your home is fairly air-tight, it is recommended that

you install outside air. If you are installing into a Mobile Home, outside air is required. See page 9.

March 27, 2008

4100-I ACT WOOD INSERT