Vents Fan Operation Manual page 3

Table of Contents

Advertisement

VN
VN
ATTENTION!
Disconnect the product from the power mains prior to all operations specific to connection, setup,
maintenance and repair.
Maintenance and installation shall only be performed by the personnel qualified for unassisted operations with
electrical installations up to 1000 V familiar with the present specification.
The single-phase mains which the product is to connected to shall be compliant with the standing regulations.
The stationary wiring shall be equipped with an automatic circuit breaker.
The connection shall be made via QF switch integrated into the stationary wiring.
The contact gap on all poles shall be at least 3 mm.
Prior to installation check for visible damage of the impeller, casing, grill and make sure there are no foreign objects
in the fan casing which may damage the impeller blades.
The product may only be used as intended. No modifications or alterations are allowed.
The unit is not intended for operation by children or any persons with reduced physical, mental or sensory capacities,
lacking practical experience or knowledge unless not controlled or briefed on the device operation by the person
responsible for their safety.
Children must remain under the supervision of adults who must prevent their playing with the device.
Take all the reasonable steps to prevent penetration of smoke, carbon monoxide and other combustion products
onto the premises through open fume ducts or other fire extinguishing equipment.
Also take steps to prevent back draft of gas from devices utilizing a gas or direct flame (except KP and KVK models).
The transported air shall not contain any dust and other hard impurities, sticky substances and fibrous materials.
Do not use the product if the handled medium contains inflammable substances or fumes such as alcohol,
gasoline, insecticides etc.
Do not close or block the device inlet and outlet so as not to impede optimum air flow.
Do not sit on the device or put any objects on top of it.
The product owner must follow this manual.
Upon service life expiry the product shall be disposed of individually.
Do not dispose of the product with unsorted municipal waste.
3

Advertisement

Table of Contents
loading

Table of Contents