Table of Contents
Advertisement
LEDs
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Table 2 lists the power supply requirements.
Table 2. Power supply requirements
Specification
Total power
Input voltage
Input line frequency
Inrush current
Harmonic distortion
Input line protection
Maximum dimensions
Redundancy
This section describes the LEDs located on front and back panels of the 2109
Model F16.
Front panel
Figure 5 shows the front panel of the 2109 Model F16 switch. The front panel
provides access to the serial port, Ethernet port, and the fiber optic ports, and
shows the corresponding port LED and the power LED.
Switch Status LED
Serial Port
Port Status LED (16X)
Figure 5. Front panel of the 2109 Model F16
The ports on the front panel are color-coded in groups (four blue ports alternate
with four blue outlined ports) to indicate which ports you can use in the same ISL
Trunking group.
Note: ISL Trunking is a feature that enables traffic to be evenly distributed across
the links between two adjacent switches while preserving in-order delivery. It
is managed through the software. For more information, see the Brocade ISL
Trunking User's Guide.
Back panel
Figure 6 on page 10 shows the back panel of the 2109 Model F16 switch. The back
panel provides access to the fan trays and the power supplies, and shows the
Value
126 watts delivered over temperature range
100 - 240 V ac, auto range
47 - 63 Hz
10 Amps peak > 300 microseconds (hot or
cold start)
Active power factor correction per
IEC1000-3-2
Fused in both hot and neutral lines
8.255 cm (3.25 in.) wide, 3.81 cm (1.5 in.)
high, and 36.83 cm (14.5 in.) deep
Dual supplies 1+1 redundant-hot-pluggable,
active current share
Optical Port (16X)
Port Speed LED (16X)
Chapter 1. Introduction
Ethernet Port
SJ000151
9
Advertisement
Table of Contents
