Step 3, Leveling; Step 4, Connect Water Supply (Zibi240 And Zibs240 Models Only) - Monogram ZIFI240 Installation Instructions Manual

STEP 2 INSTALL CUSTOM 3/4" DOOR
PANEL AND HANDLE
(ZIFI240 and ZIBI240 models only)
Install custom door panel and handle (cont.):
• A custom handle of your choice, supplied by your
cabinetmaker, must be installed onto the overlay
panel before the panels are slid into the trim.
Countersink all screws into the backer panel.
Screws cannot protrude from the backer panel.
Screws Must
Be Countersunk
Into Panel
Custom
Door Panels
• Slide overlay panel into the door trim.
• Reinstall the side trim using the trim screws
removed earlier.
• Place the brushed decorative cover over the side trim
to hide the screw heads. Ensure side trim is aligned
top to bottom and front to back. Snap into place.
NOTE:
For shipping
purposes, the
brushed decorative
cover will be
secured to the
front of the unit.
Installation Instructions
(CONT.)
Handle
STEP 3 LEVEL
• Use an adjustable wrench
to turn the leveling legs
and raise or lower the product.
For built-in installation, adjust
the leveling legs slightly below
the bottom of the countertop.
INSTALLATION TIP:
Measure floor to underside
of countertop inside the
opening. If the room
floor is higher than the
opening floor, adjust the
rear leveling legs
approximately 1/8" less than the opening height.
Screw front legs all the way in to shorten the height at
the front. This will allow you to slightly tip the unit
into the opening. Once in the correct position, the
front legs can be adjusted to level the product.
STEP 4 CONNECT WATER SUPPLY
(ZIBI240 and ZIBS240 models only)
1/4" Tubing
SmartConnect ™ Tubing
• Locate and bring the water line tubing to the rear
of the cabinet.
• Turn the water on to flush debris from the line.
Run about a quart of water through the tubing
into a bucket, then shut off the water.
Copper Tubing:
• Slip a 1/4" nut and ferrule over both ends of the
copper tubing. Insert the tube into the refrigerator
connection on the unit and tighten the nut.
• Turn on the water to check for leaks.
GE SmartConnect
• Insert the molded end of the tubing into the
refrigerator connection. Tighten the compression
nut until it is just hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
NOTE: Coil excess tubing length behind the unit.
7
Turn Right to Lower
Turn Left to Raise
™ Tubing:
1/4"
Compression
Nut
Ferrule
(sleeve)
Refrigerator
Connection