Table of Contents
Advertisement
Setting up the uninterruptible power supply with an extended battery
module
Note: Two sets of pedestals and two extended battery module brackets are
required for this tower configuration.
To set up the uninterruptible power supply with an extended battery module in a
tower configuration, complete the following steps:
1. Unscrew and remove the mounting brackets on both sides of the uninterruptible
2. Place the uninterruptible power supply chassis horizontally so that the left end
3. Position two of the pedestals over the edge of the chassis so that the weight of
4. Place the extended battery module chassis upside down so that the right side of
5. Position two of the pedestals over the edge of each chassis so that the weight
8
UPS 3000 LV and UPS3000 HV: Installation and Maintenance Guide
power supply and the extended battery module.
of the unit is accessible (see the illustration in step 3).
the unit is evenly distributed. Secure the pedestals with the 6-32 x 3/8" flat-head
screws that come in the accessory kit.
the unit is accessible (see the illustration in step 5).
of the unit is evenly distributed. Secure the pedestals with the 6-32 x 3/8-inch
flat-head screws that come in the accessory kit.
Mounting
bracket
Hide quick links:
Advertisement
Table of Contents
