Dummy Carrier Modules; Engaging The Anti-Tamper Locks; Power Cord Connection; Parts Check List - Impediment RS-0800-LVD User Manual

RS--0800-LVD User Guide

2.9.3 Dummy Carrier Modules

Any unused drive bays must be fitted with a dummy carrier module.

2.9.4 Engaging the Anti-tamper Locks

The anti-tamper locks are fitted in the drive carrier handles and are accessed through the small cutout in
the latch section of the handle.
Drives are supplied with the locks set in the unlocked position.
2.9.4.1 Activating the Locks
1 Carefully insert the lock key provided into the cutout in the handle.
2 Locate the key into its socket.
3 Rotate the key in a clockwise direction until the indicator is visible in the aperture beside the key.
).
Figure 2–13 Activating the Anti-tamper Lock
4 Remove the key.
De-activation is the reverse of this procedure, that is:
• Rotate the key in a anti-clockwise direction until the indicator is no longer visible in the aperture
Note A drive carrier cannot be installed if its anti-tamper lock is activated outside the Enclosure.

2.10 Power Cord Connection

2.10.1 Parts Check List

• Bifurcated power cord
• Power cord to requisite local standards

2.10.2 Procedure

1 Attach the Bifurcated power cord to the Power Supply modules,
2 Attach the power cord to the in-line IEC connector in this cord.
28
beside the key.