Installation - OpenVox B100E on DAHDI User Manual

3.2 Installation

1. Hardware detection
# lspci –vvvv
Check the outcome and confirm your system has recognized B100E. If it
has been recognized, "Network controller" will be displayed in the output
information like that:
02:0b.0 Network controller: Cologne Chip Designs GmbH ISDN network
controller [HFC-PCI] (rev 02)
ParErr- Stepping- SERR- FastB2B- DisINTx-
>TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
[size=256]
PME(D0+,D1+,D2+,D3hot+,D3cold-)
If B100E is not recognized by the system, you have to power off and take
out the card to insert it into another PCI slot.
OpenVox Communication Co. LTD.
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Subsystem: Cologne Chip Designs GmbH ISDN Board
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium
Latency: 16 (4000ns max)
Interrupt: pin A routed to IRQ 177
Region 0: I/O ports at dfe0 [disabled] [size=8]
Region 1: Memory at feafac00 (32-bit, non-prefetchable)
Capabilities: [40] Power Management version 1
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Kernel driver in use: vzaphfc
Kernel modules: zaphfc, hisax
Figure 4 Hardware detection
B100E on DAHDI User Manual
URL: www.openvox.cn
16