Locate The Mounting Holes - Sun Microsystems Fire V440 2-Post Manual

Locate the Mounting Holes

Use the Rack Alignment template to locate and mark the holes for the mounting
screws on each vertical rack rail. Allow four rack unit spaces (7.0 inches/17.8 cm)
per server.
To use the Rack Alignment template, complete these steps:
a. Place the Rack Alignment template over the vertical rack rail, with the side
marked for 2-post rack installation facing out.
b. Place the Rack Alignment template in the space where the server will be
installed, lining up the bottom of the Rack Alignment template with the top of
the server below. See next figure.
c. Adjust the Rack Alignment template so that the mounting hole is centered on a
rack rail hole and mark that rail hole.
Installing a Sun Fire V440 Server Into a 2-Post Rack 5