Chapter Ix Body Dimension; Basic Instructions On Biw Maintenance - Chery S18D Service Manual

Body accessories & dimensions

Hide thumbs

Table Of Contents

Table of Contents

Chery S18D Service Manual

I. Basic Instructions on BIW Maintenance

Vehicle body maintenance should be carried out by professionals according to the requirements of the

manufacturer, and only in this way will the promises of "rust free" and "paint defect free" be effective.

Only adopt the materials specified by the manufacturer;

When welding the outside metal of the vehicle body, make sure protective coating is applied to

the inner side;

When spot-welding, make sure zinc coating is used;

Before air-tight sealing the welded parts, apply a layer of filling coating to the inner side and

outer side;

Before protecting the chassis with paint, apply protective coating to protect the chassis from

rock bumping;

When the coating is sprayed, all opening parts at this position should be secured with

fasteners;

In some cases, the vehicle must be placed on a hoister platform, for removal of spare parts may affect

the distribution of various parts in the vehicle body.

Before spot-welding, make sure the battery connector is unplugged, and check if the ventilation is good

enough before welding.

In maintaining the vehicle body in a certain area, take care to protect other vehicles in this area.

Be particularly careful when spraying sand or welding near the oil tank or fuel system, and disassemble

them if the safety can not be assured.

When maintaining or spray-painting the vehicle body, take all possible measures of preventing

accidents.

When welding galvanized steel sheets, the spot-welding current should be raised by 30%, and the

electrodes should be pointed, and the clamping force of the electrodes should be increased; and when

doing gas shielded welding, the welding current should be further intensified.

Do not weld the air-conditioning parts or try to weld the parts on the vehicle whose temperature are

easily raised. When spray-painting the vehicle frame, the temperature either in the drying oven or the

pre-heating oven should not go beyond 80˚C.

Take the following measures during welding operation to prevent shaking the electronically welded

equipment:

Connect the grounding of the electronic welding equipment directly to the welded parts. And check to

make sure no other parts or insulative parts exists between the ground wiring connector and the spot-

welded parts;

First disassemble the ECU, and prevent the electronic device or circuit from contacting the ground

wiring connector or welding wire.

Corrections:

The vehicle body and the chassis are manufactured off the production-line by low-temperature

tempering and cold die casting. Therefore, when the metal parts are damage in any accident, the same

processes must be used to restore them, and no heating is allowed. If they are damaged very seriously

and can not be restored, the damaged parts must be removed after the connecting surface is corrected.

The car bodies are made up of various members, pressing panels and other parts, of which the doors

are the most complexly processed parts of the vehicle body. They involve processes like part stamping

and welding, assembly of spare parts and assemblies, for which the dimensional fits and technical

requirements are quite strict, so the car doors are difficult to maintain and the quality requirements are

fairly high, and only the service personnel understand the structure of the car doors thoroughly and are