Installation Procedure; Methods For Clearing Instrument Maintenance Indicator; Removal Of Instrument Panel Cross Beam; Removal Procedure - Chery S18D Service Manual

Chery S18D Service Manual
Note:
1. Disconnect the battery
removing the electrical equipment.
2. Don't wait until all the instrument panel bolts
are removed before you remove the ones on
the other side, or the instrument panel are
likely to get deformed.

2. Installation Procedure

The installation procedures are reverse to those for removal.
Note:
① . Double-wind channels should agree with the air-conditioner outlet connector and be installed
properly without any air leak, and the Instrument Panel air channel should not conflict with the
Instrument Panel crossbeam, the evaporator and other parts, or the Instrument Panel and its
accessories will not be installed properly.
② . The Instrument Panel should not interfere with the front windscreen or affects its installation and
the clearance shall be even.
③ . The clearances between the instrument panel and either sides of the vehicle body should be
consistent and meet the requirements for assembling the door weather strips.

3. Methods for Clearing Instrument Maintenance Indicator

Following is the clearing method:
① . Insert the key into the ignition switch and turn the key to the position "ACC";
② . Press the adjusting button by hand and hold it, then turn the key to "ON" position;
③ . Press the adjusting knob and hold it for about 20 seconds before you release the knob, and then
the maintenance indicator will be cleared.
II. Removal of Instrument Panel Cross Beam
Tools: socket wrench, cross screwdriver, slotted screwdriver and etc.
Parts: harness strap

1. Removal Procedure

1.1. Remove the instrument panel assembly (see
the removal of instrument panel)
1.2. Remove the connector of interior wiring
harness and instrument panel wiring harness.
negative before
45