Installation Procedure - Chery S18D Service Manual

Chery S18D Service Manual
3.2. Use a cross screwdriver to loosen off the
screws fixing the rear bumper bottom and the
vehicle body.
3.3. Use a 7# socket wrench to loosen the screws
connecting the fender and the bumper.
3.4. Apply the force vertical to fender surface to
outwards to separate the bumper and fender
clips and remove the bumper.
Note: notice the force applied to avoid the damage
of clips during removal.
3.5. Remove the connectors of reverser radar and
left & right rear fog lamp.
Note: notice to avoid the wiring harness being
pulled by bumper when removing the wiring
harness connector.
3.6. Remove the rear bumper rod.
(the rear bumper rod is fixed with wheelhouse by
clips, notice to avoid the damage of clips during
removal of rear bumper rod)
3.7. Push the reverse radar from inside of bumper
towards outside to remove the reverse radar.
Note: during the installtion of reverse radar, the
locating pin of reverse radar shall be aligned with
the bumper locating hole (as right figure).

4. Installation Procedure

The installation procedures are reverse to those for removal.
28