HP ProCurve 8100fl Series Installation And Getting Started Manual page 56

Installing the ProCurve Switch 8100fl
Installation Procedures
To verify the installation:
1. Make sure all exposed interface module slots and power supply bays are
2. Check the power supplies to make sure they are attached to your power
3. Connect an active terminal or a PC running terminal emulation software
4. Verify proper operation by observing the LEDs. Make sure the LED on
N o t e s o n L E D s
■
■
■
2-30
free of foreign objects, such as tools, and have the correct slot covers.
source.
to the console port on the switch chassis (labelled Console for MM-A
or Console for MM-B) for the active management module (see
for details). The active management module (MM-A or MM-B) has its
Active LED lit (green).
each power supply and fan tray assembly is a solid green. Also, make sure
that the Status LED on each active module is solid green.
The Link and Activity LEDs on the X2 10-GbE modules (J8736A and
J8737A) will go on for two seconds when a transceiver is inserted into
the port. They will then go off until a network cable is plugged into the
transceiver and the LEDs follow their normal operational behavior (see
page 1-11).
The Activity LED on the 1-Port 10-GbE LR Module (J8733A) will flash once
every four seconds. This is a safety feature known as Auto Laser Shut­
down.
The Link Status LED for the ports on the 10-Port 100/1000Base-T Module
(J8734A) will show solid green when a port is connected at 1000 Mbps,
and solid amber when a port is connected at 100 Mbps.
For more details on specific LED conditions, see
page 2-27
"LEDs" on page 1-6.