HP ProCurve 8100fl Series Installation And Getting Started Manual page 47

6. Tighten the captive screw on each ejector by hand and seat with a screw
1. Pull out upper ejector
lever to hold it in
unlocked position.
C a u t i o n
7. Repeat steps 1 to 6 to install a secondary management module to provide
driver to keep the module from being removed accidentally. Do not
overtighten the captive screws. (You can tighten the thumb screws with
a P2 Phillips screwdriver to eliminate the possibility of casual removal by
unauthorized personnel.)
3. Push in ejectors in to
secure and tighten
captive screws.
Metal Plate
Module Guides
The management module must be fully seated and the ejectors fully
locked (vertical) before the captive screws will align properly. Also, fully
seating the card ensures proper contact of the card with the backplane
which is necessary for optimal performance.
full (100%) redundancy in the event of a failure of the primary module.
Installing the ProCurve Switch 8100fl
2. Install management
modules on either side
of the two central slots.
Management
Module
Installation Procedures
2-21