Section Iii: Pre-Fab Insert Installation - BuckMaster 21 Operation Maintenance Saferty

PRE-FAB INSERT INSTALLATION
The Model 21 has been tested with the following:
Heatilator Security
Tempco Preway
Marco FMI
Woodside Majestic
NOTE: The Model 21 may be installed in any of the pre-fabricated fireplaces listed above if
they are big enough to accept the heater.
NOTE: A FULL CHIMNEY LINER IS REQUIRED IN A ZERO CLEARANCE OR
PRE -FABRICATED FIREPLACE.
NOTE: The ash lip, smoke baffle and smoke shelf may be removed if necessary to provide
room for these models. Any other alteration to the unit will void ALL NEW
BUCK CORPORATION, responsibility and liability. The warning label below
must be attached to the pre- fabricated fireplace before unit is installed.
"NOTES"
Except for the
Installation including Minimum Clearances for stove and floor protector in Section II.
NOTE: When installing trim panels "DO NOT COVER ANY EXITING LOUVERS OR
AIR OPENING IN PRE-FABRICATED FIREPLACE ."
SECTION III
above, please follow the instructions for Masonry Insert
WARNING:
This fireplace must be
restored to its original condition for safe use,
if the fireplace insert is removed.
Page 11