Simrad Axis 200 User Manual page 16

MS - Memory Scan (F-Channel Up)
This function operates in the same way as the
Scanning function (F-Channel Down), except
that it will only scan channels that have been
entered into the Scan Memory. If no channels
have been entered into the memory, then this
function will not be available.
- Channel Inhibit (F-Squelch Down)
Since the Scanning function operates by stop-
ping on channels where a signal is detected, the
function will lock onto a channel with a lot of
interference noise, or if a channel is transmit-
ting a continuous carrier wave signal. This will
prevent the radio from continuing its scan of
the other channels.
The Inhibit function allows unwanted channels
to be removed from the Scanning function
while remaining available for use on the radio.
Pressing F-Squelch Down will inhibit the cur-
rent channel – indicated by 'INH' appearing on
the bottom line of the LCD display (Fig 2.12).
When that channel is subsequently selected, a
legend will be shown on the bottom line of
the LCD display indicating that the channel is
inhibited from the Scanning function.
Pressing F-Squelch Down if the channel is
already in inhibited will restore it to the Scan
function – indicated by 'SCAN' appearing on
the bottom line of the LCD display.
Mem (F-Channel Up held for two seconds)
This function allows the radio to operate only
on the channels held in the Scan Memory -
indicated by 'MEM' shown on the LCD dis-
play. If the Scanning function is selected, it will
operate the same way as the Memory Scan
function.
Pressing CH16 or F-Channel Up held for
two seconds will return the radio to normal
operation.
Page 16
Rx
D/W 16
SQ
M+
SQ
F
F
AS
Rx
D/W
16
SQ
M+
SQ
SQ
F
AS
Fig 2.12 - Inhibiting channel from Scan
VOL
SIG
VOL
CH
MS
CH
VOL
SIG
VOL
CH
MS
CH