Table of Contents
Advertisement
PowerScan
™
PowerScan
A rapid configuration procedure has been devised for point-to-point applications
where a single reader is associated exclusively with its own BC-80X0 base station
and where it is not necessary to set the Date and Time parameters.
A special pre-printed bind-address label provided in the BC-80X0 base station
package can be used to bind the PowerScan
station with the address coded on the label. The address is also written
numerically on the label to be easily recognized. Valid addresses are in the range
from 0000 to 1999. Make sure that all cradles used in the same area have different
addresses.
To rapidly configure your point-to-point application:
1.
Apply the bind-address label onto the BC-80X0 base station as indicated
in the BC-80X0 Quick Reference Manual.
2.
When the BC-80X0 cradle is connected and powered, read the
Bind-Address label to pair the PowerScan
80X0 cradle.
The green LED on the PowerScan
is ready to be positioned onto the cradle.
Firmly position the reader onto the cradle within 10 seconds, a beep will
3.
be emitted, signaling that the BC-80X0 cradle has been paired to the
PowerScan
4.
Configure the BC-80X0 cradle, refer to the "BC-80X0 Quick Reference".
END of procedure. YOUR READER IS NOW READY TO READ CODES.
Quick Reference Guide
™
PM8300-DK Configuration
PM8300-DK/BC-80X0 Point-to-Point Setup
™
PM8300-DK, and the green LED on the reader will go off.
Green LED
PowerScan™ PM8300-DK Configuration
™
PM8300-DK reader to the base
™
PM8300-DK to the BC-
™
PM8300-DK will blink: the reader
If it ever becomes necessary to
change the reader, just read the
bind-address label applied to
the cradle and position the new
reader onto the cradle.
Do not use multiple readers
with
method.
this
configuration
9
Advertisement
Table of Contents
