Stapled Prints - Oce VarioPrint 2105 Manual For Use

Stapled prints

Introduction
The Océ VarioPrint 2105 finisher has two staplers for stapling sets. You can
staple in three different ways.
1 staple in portrait direction
2 staples
1 staple in landscape direction.
To create a document with a landscape staple you only have to select the
correct document type.
[55] Staple function
[55] Staple function
If your set turns out to be too thick to staple (this is measured), a dialog is
displayed on the screen. You can do the following:
Continue without staples.
Cancel the job.
If one of the staplers is or runs empty, a dialog is displayed on the screen. You
can do the following:
Continue without staples.
Refill the staplers.
Cancel the job.
If the margin is too small for staples, you can shift the margin.
Note:
132 Océ VarioPrint 2105 Job manual