jablotron JA-63 „Profi“ User Manual page 6

User codes and controllers
code
user name
index
0.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
c1
c2
c3
c4
c5
c6
c7
c8
Telephone communicator setting
memory calling to
1.
2.
3.
4.
5.
exit delay
entrance delay
alarm duraton
Notes:
Alarm system JA-63 „Profi"
section
notes
A B
Master code - supervisor
tel. number notes
Pager
Timers
sec
sec
min
- 14 -
Note: features of this system can be substantially modified by programming
during installation. The installer should instruct the users how to operate and test
the system.
1 Indicators
The alarm system's status is indicated on the keypad. There can be multiple
keypads in the system and in such a case all keypads will have identical functions.
A keypad's LED indicators and display inform the user about the conditions of the
system.
88
display specifies event source:
MGK51503 Alarm system JA-63 „Profi"
LED indicators:
Alarm: alarm triggered by an intruder, smoke, gas etc
Tamper: opened cover, damaged detector, excessive
number of attempts to enter code, etc.
Fault: power loss, lost communication with a detector
etc., (view details by pressing N)
Battery: battery of the device specified on the display is
low. See battery replacement section.
information received from a wireless item or wireless
communication of the keypad in progress
Armed: continues = armed, slow blinking = exit delay,
fast blinking = entrance delay
Power: continues = AC power & back up battery O.K.,
blinking = failure (AC or back up battery), off = control
panel is not powered
wireless indicated event (Alarm, Tamper, Failure or
detector 12 Battery) was caused by detector number 12
indicated event (Alarm, Tamper, Failure or
wired zone 2
Battery) was caused by wired zone number 2
indicated event was caused by wireless
wireless
controller (remote control, keypad, Panic button)
controller 3
indicated event (Tamper or Failure) was caused
Control panel
by the control panel
indicated event (Tamper, Failure or Battery)
Wireless siren
was caused by the outdoor wireless siren
Sub control indicated event (Alarm, Tamper, Failure or
panel Battery) was caused by the sub control panel
- 3 -
number 3
MGK51503